Water under a raised-floor Sun Valley house
Postwar tract houses in Los Angeles often have concrete slab floors rather than raised floors with wood joists[LA City Planning], but older homes are a different story. In ZIP code 91352, 23% of homes were built before 1950[U.S. Census Bureau], and many houses from that era sit on raised foundations with a crawl space underneath.
Water from a leaking supply line, a drain or heavy rain can pool in the crawl space and stay out of sight until floors soften or a damp smell comes up through the house. The state’s Earthquake Brace + Bolt program, which helps owners retrofit raised-foundation homes, picks ZIP codes partly by their share of pre-1940 houses[Earthquake Brace + Bolt].
Crawl space water removal usually means a submersible pump for standing water, removal of wet insulation and torn vapor barrier, then dehumidifiers and air movers under the house. The EPA target of indoor humidity below 60 percent applies under the floor too[EPA].
Step by step
- Find the source. Plumbing leak, drain line or surface water.
- Pump out. Submersible pump clears standing water.
- Remove wet materials. Insulation and vapor barrier that will not dry.
- Dry under the house. Dehumidifiers until readings show dry.
Do
- Turn off water if a plumbing leak is the source.
- Keep the crawl space access closed between visits.
Avoid
- Crawling into standing water near wiring[CDC].
- Leaving wet insulation hanging on the joists.
When a leak is bigger than it looks
- Water has been sitting for more than a day, or you do not know how long it was there
- Carpet is wet across a room, or the pad squishes when you step on it
- Drywall is soft, stained or swollen at the bottom
- Water came through a ceiling or reached a second room
- The water came from a toilet, drain or the outside
- There is a musty smell after the surface has dried
Any of these usually means water has moved into materials you cannot dry with towels and a fan. A moisture meter will show how far it went.
Water categories and why they change the job
The IICRC splits water into three categories. Its examples of grossly contaminated Category 3 water include sewage, waste line backflows from beyond a trap, seawater flooding, rising rivers or streams and contaminated wind-driven rain[IICRC 2026 position statement].
The category decides the order of work. Category 1 drying can start right away, while Category 2 and 3 losses get cleaned up under contamination controls before drying begins[IICRC 2026 position statement]. Storm water is not automatically Category 3; the restorer decides after inspecting[IICRC 2026 position statement].
Time matters too. The IICRC notes that time and temperature can change the category[IICRC 2026 position statement], so a clean leak left sitting for days can be treated as contaminated water.
Water removal and drying equipment used in Sun Valley
- Moisture meters. Pin and pinless meters read moisture in drywall, wood and subfloor so the crew can map the wet area and track progress.
- Thermal cameras. Infrared cameras show temperature differences that often point to wet areas behind walls and under floors. Readings are confirmed with a meter.
- Extraction units. Truck-mounted and portable extractors pull water from carpet and pad; submersible pumps handle deeper water.
- Air movers. High-velocity fans move air across wet surfaces so moisture evaporates faster.
- Dehumidifiers. Refrigerant and desiccant dehumidifiers pull that moisture out of the air so it does not soak back into the house.
- Wall cavity drying. Small holes or removed baseboards let air reach the inside of wet walls without tearing out the whole wall.
After the shaking: water lines and water heaters
The magnitude 6.7 Northridge earthquake struck at 4:30 in the morning on January 17, 1994, on a buried thrust fault rooted under the San Fernando Valley[USGS]. It left more than 7,000 people injured and 20,000 residents homeless, with property damage estimated at about 40 billion dollars[USGS].
Shaking strong enough to topple water heaters and break water mains is one of the effects the USGS lists[USGS]. State law requires every residential water heater to be braced, anchored or strapped[California Health and Safety Code 19211], and the state’s bracing guidelines recommend flexible water and gas connectors along with at least two straps[California DSA].

Once the shaking stops and it is safe to move around, look for running water at the water heater, toilets and sink lines, and close the main shut-off if anything is leaking.
When a drain backs up into the house
Sewage is Category 3 water[IICRC 2026 position statement]. Keep children and pets out of the area, do not run fans that blow air from the wet room into the rest of the house, and do not try to dry it in place. Soaked carpet, pad and drywall are removed and the area is cleaned and disinfected before drying.
In the City of Los Angeles, the public sewer main belongs to the city, but the property owner is responsible for the entire sewer lateral, from the building to the street connection. LA Sanitation also says that if any fixture in a home sits lower than the street manhole cover, the property needs a backwater valve, which requires a permit from the Department of Building and Safety[LA Sanitation].
Talking to the restoration company
- Which IICRC category does this water fall into?
- Can you show me the moisture readings and the wet area on a sketch?
- Which materials are coming out, and which can be dried in place?
- When will you take readings, and when do you expect the job to be dry?
- Do I need a plumber to stop the source first?
- Will you put the scope of work in writing before you start?
A good restoration company will answer these without hesitating and will take readings before giving a plan.
Once the house is dry
Keep the final moisture readings and the drying log with your photos. Check the area again over the next few weeks for odors, stains or swelling, which can mean water was missed. The EPA notes that cleanup is not finished until the water or moisture problem itself is fixed[EPA].
Crawl space water removal and Sun Valley homes
In ZIP code 91352, 61% of the 13,310 housing units are detached houses and 31% are apartments, condos or other multi-unit homes; owners live in 50% of occupied units[U.S. Census Bureau]. 77% of homes in ZIP code 91352 were built before 1980 and the median year built is 1961[U.S. Census Bureau]. Original supply lines, drain lines and water heater connections in houses that age are common starting points for leaks.
Water service in Sun Valley is LADWP’s. If water is coming up at the meter, the curb or the street, call 1-800-DIAL-DWP (1-800-342-5397); LADWP lists that line for water trouble at any hour[LADWP].
Other services in Sun Valley
- Water damage restoration in Sun Valley
- Emergency water removal
- Water extraction
- Water mitigation
- Water damage cleanup
- Flood restoration
- Flood cleanup
- Sewage cleanup
- Burst pipe water damage