Call (855) 671-4316
Water removalWater extractionStructural dryingFlood and sewage cleanup

Water damage help

Burst pipe water damage: what to know

Burst pipe water damage is the water side of a plumbing failure: extraction, opening wet walls and drying.

Close the main shut-off first. The pipe itself is a plumbing job; the water it released is a restoration job. In a San Fernando Valley home, that means extraction, removal of wet drywall and insulation, and drying.

Supply-line water starts clean but does not stay that way once it soaks into building materials[IICRC 2026 position statement]. The EPA’s drying window is 24 to 48 hours[EPA].

Water spraying from a failed supply line under a sink

Typical steps

  1. Shut off the main. Know where it is before you need it.
  2. Call a plumber. For the pipe itself.
  3. Extract and open up. Water removed; wet drywall and insulation cut out.
  4. Dry. Equipment runs until readings show dry.

Do

  • Turn off the water heater if the main is off for long.
  • Photograph the damage[FEMA].

Avoid

  • Turning the water back on before the pipe is fixed.
  • Using ceiling fixtures below a wet ceiling.

When a leak is bigger than it looks

  • Baseboards or door casings are swelling
  • Vinyl plank or laminate is lifting or cupping
  • Stains are spreading on a ceiling or wall
  • Water reached cabinets, closets or a hallway
  • A drain or toilet backed up
  • A damp smell stays after the floor feels dry

Any of these usually means water has moved into materials you cannot dry with towels and a fan. A moisture meter will show how far it went.

How restoration crews in the San Fernando Valley classify water

Category 1Clean source: a supply line, faucet or water heater.
Category 2Significant contamination: for example, washer or dishwasher discharge.
Category 3Grossly contaminated: sewage, rising rivers or streams.

The IICRC splits water into three categories. Its examples of grossly contaminated Category 3 water include sewage, waste line backflows from beyond a trap, seawater flooding, rising rivers or streams and contaminated wind-driven rain[IICRC 2026 position statement].

The category decides the order of work. Category 1 drying can start right away, while Category 2 and 3 losses get cleaned up under contamination controls before drying begins[IICRC 2026 position statement]. Storm water is not automatically Category 3; the restorer decides after inspecting[IICRC 2026 position statement].

A clean leak does not stay clean forever. Time and temperature can change the category[IICRC 2026 position statement], and a warm house speeds that up.

What the restoration crew brings

  • Pumps and extractors. Submersible pumps remove deep water. Extraction wands and weighted tools pull water out of carpet and pad.
  • Air movers. Fans set at angles along walls and floors move air across wet materials.
  • Dehumidifiers. Remove water from the air. Without them, air movers just push damp air around the room.
  • Moisture meters. Measure the water in drywall, framing and subfloor, and confirm when each area is dry.
  • Infrared cameras. Help locate wet areas behind finished surfaces, with meters used to confirm.
  • Containment. Plastic sheeting closes off the work area, which keeps contaminated water and drying air where they belong.

What can be saved and what usually goes

The deciding factors are the type of water and how long things stayed wet. The EPA says materials that cannot be thoroughly cleaned and dried within 24 to 48 hours should be discarded[EPA flood cleanup guide], and the CDC adds that items which cannot be disinfected, such as wall coverings, cloth, rugs and drywall, should be thrown away[CDC].

With clean water caught early, the EPA notes that wallboard, fiberglass insulation and wall-to-wall carpet may sometimes be dried and saved, though replacing them can avoid indoor air problems later[EPA flood cleanup guide].

Photograph everything before it goes to the curb[FEMA], and keep a list of what was removed.

Earthquake water damage in the Valley

The magnitude 6.7 Northridge earthquake struck at 4:30 in the morning on January 17, 1994, on a buried thrust fault rooted under the San Fernando Valley[USGS]. It left more than 7,000 people injured and 20,000 residents homeless, with property damage estimated at about 40 billion dollars[USGS].

Shaking strong enough to topple water heaters and break water mains is one of the effects the USGS lists[USGS]. State law requires every residential water heater to be braced, anchored or strapped[California Health and Safety Code 19211], and the state’s bracing guidelines recommend flexible water and gas connectors along with at least two straps[California DSA].

Gas water heater with two earthquake straps and a small puddle on the garage floor

After an earthquake, check the water heater, the lines under sinks and the main shut-off before anything else. If water is running, close the main and keep out of rooms where water has reached outlets[CDC].

Toilet and drain backups

Sewage is Category 3 water[IICRC 2026 position statement]. Keep children and pets out of the area, do not run fans that blow air from the wet room into the rest of the house, and do not try to dry it in place. Soaked carpet, pad and drywall are removed and the area is cleaned and disinfected before drying.

LA Sanitation explains the split: the city owns the sewer main, and the private lateral from the house to the middle of the street is the owner’s responsibility. When any plumbing fixture in the home sits below the street manhole cover, a backwater valve is required, permitted through the Department of Building and Safety[LA Sanitation].

Questions to ask the restoration company

  • Which IICRC category does this water fall into?
  • Can you show me the moisture readings and the wet area on a sketch?
  • Which materials are coming out, and which can be dried in place?
  • When will you take readings, and when do you expect the job to be dry?
  • Do I need a plumber to stop the source first?
  • Will you put the scope of work in writing before you start?

A good restoration company will answer these without hesitating and will take readings before giving a plan.

Once the house is dry

Ask for a copy of the final readings and keep them with your damage photos. In the weeks after, watch for a damp smell, new stains or swelling floors. Fix the source for good; the EPA is clear that the water problem must be fixed or it comes back[EPA].

Burst pipe water damage by community

Burst pipe water damage

Call to be connected with an independent restoration company.

Call (855) 671-4316
Call (855) 671-4316